> ## Knowledge Base Index
> Fetch the complete knowledge base index at: https://docs.fysetc.com/sitemap.xml
> Use this file to discover available pages before exploring further.
> Pure-Markdown content can be obtained by appending a '.md' suffix to the content URLs listed in the sitemap (without the trailing slash).

# Assembly Guide - 6 - Drag chain components

# 2.6 Drag chain components
![](https://raw.githubusercontent.com/FYSETC/wiki.fysetc/main/docs/images/crisp/venture-xl-assembly-guide-drag-chain-components--drag-chain-components.png)

## 2.6.1 X-Drag Chain
* Assemble according to the diagram；
* Open the movable buckle on the back of the drag chain and insert the CAN line and the light bar power line；
* Use M3x8 BHCS screws to fix one end of the drag chain to the extruder head and the other end to the profile；
* CAN line plugged into the CAN board；The back of the XY drag chain is fixed with a drag chain buckle
![](https://raw.githubusercontent.com/FYSETC/wiki.fysetc/main/docs/images/crisp/venture-xl-assembly-guide-drag-chain-components--x-drag-chain.png)
### Gantry light bar power board
* The light bar cable is connected to port ①，See page 33；
* Port ② faces the drag chain and uses the power cable to connect to the CAN board；
  ![](https://raw.githubusercontent.com/FYSETC/wiki.fysetc/main/docs/images/crisp/venture-xl-assembly-guide-drag-chain-components--gantry-light-bar-power-board.png)
  
## 2.6.2 Y-Drag Chain
* Open the movable buckle on the back of the drag chain and insert the CAN line power line；
![](https://raw.githubusercontent.com/FYSETC/wiki.fysetc/main/docs/images/crisp/venture-xl-assembly-guide-drag-chain-components--y-drag-chain-01.png)
![](https://raw.githubusercontent.com/FYSETC/wiki.fysetc/main/docs/images/crisp/venture-xl-assembly-guide-drag-chain-components--y-drag-chain-02.png)
## 2.6.3 Z-Drag Chain
* Attach the cooling fan to the tail of the motor；
* Place the fan wire and motor wire B into the aluminum profile slot and cover them with the aluminum profile slot cover.
  ![](https://raw.githubusercontent.com/FYSETC/wiki.fysetc/main/docs/images/crisp/venture-xl-assembly-guide-drag-chain-components--z-drag-chain-02.png)
  
* Pass the AB motor wires and CAN board connection wires through the Z drag chain；
* Fix the drag chain with the drag chain fixings and tighten the screws；
  ![](https://raw.githubusercontent.com/FYSETC/wiki.fysetc/main/docs/images/crisp/venture-xl-assembly-guide-drag-chain-components--z-drag-chain-01.png)

  **NOTE: Note where the cables pass through.**

### This chapter is assembled

---
## Related articles
* [← Previous: Assembly Guide - 5 - Extrusion head assembly](https://docs.fysetc.com/en/article/assembly-guide-5-extrusion-head-assembly-1x5ed7z/)
* [Assembly Guide overview](https://docs.fysetc.com/en/article/assembly-guide-e4h7du/)
* [Next: Assembly Guide - 7 - Caster Assembly →](https://docs.fysetc.com/en/article/assembly-guide-7-caster-assembly-5be60a/)